User manual

6. Fasten the lower mounting pole (which is swaged on the top end) to your mounting pole or

bracket (purchased separately) with the two U-Bolts, clamps and nuts as shown in Figure 6.

Tighten the lower mounting pole to your mounting pole with the mounting clamp assembly

with a wrench, as shown in Figure 6. Slide the top weather station pole (with the sensor

array) into the lower pole (connected to your mounting pole) when your station is finally

mounted.

Attach the upper mounting poke to your mounting pole with the second mounting clamp

assembly with a wrench, as shown in Figure 6.

When you install the weather station, you will need to calibrate the anemometer pointer to

true north. True north can be estimated with a compass (which points to magnetic north) or a

GPS, which provides true north. Wind direction is defined as the direction the wind is coming

from (example, Winds from the north).

Note the four channels on the side of the wind vane. Each quadrant is labeled North, South,

East and West (reference Figure 6 as an example for “E” or East). Locate the North direction

(“N”) and mark it with a piece of tape for future reference. You will need this for wind

direction calibration upon final assembly.