User manual

wind meter (available from Ambient Weather) and a constant speed, high speed fan.

6.13.4 Calibration Mode

While in the Normal Mode, press the ON/OFF key for 8 seconds to enter the calibration mode, and

the ADJ icon will be displayed. You can skip over any setting by selecting the enter key. To exit the

calibration mode at any time, select the history key

1. Wind Speed Calibration (default is 1.0, adjustment range 0.75 to 1.25). Press the up or

down key to increase or decrease the wind speed multiplier to match the calibrated source.

Press the ON/OFF key, and the value will return to the uncalibrated value.

2. Indoor Temperature Calibration. Press the enter key to calibrate the temperature in 0.1°C

(0.18 °F) increments. Press the up or down key to increase or decrease the temperature bias

to match the calibrated source. Press the ON/OFF key, and the value will return to the

uncalibrated value.

3. Indoor Humidity Calibration. Press the enter key to calibrate the humidity in 1%

increments. Press the up or down key to increase or decrease the humidity bias to match the

calibrated source. Press the ON/OFF key, and the value will return to the uncalibrated value.

4. Outdoor Temperature Calibration. Press the enter key to calibrate the temperature in 0.1°

increments. Press the up or down key to increase or decrease the temperature bias to match

the calibrated source. Press the ON/OFF key, and the value will return to the uncalibrated

value.

5. Outdoor Humidity Calibration. Press the enter key to calibrate the humidity in 1%

increments. Press the up or down key to increase or decrease the humidity bias to match the

calibrated source. Press the ON/OFF key, and the value will return to the uncalibrated value.

Press the enter key to exit the calibration mode.

Note: The dew point and wind chill are based on the calibration values.

6.14 Lost Sensor Resynchronization

If the signal is lost between the remote sensor (or transmitter) and the display console (or the receiver),

to resynchronize, while in normal mode, press and hold the down key for 5 seconds. The transmitter

search icon will appear.

Please wait several minutes for the search icon to turn off and the remote sensor reports in. Do not

touch any buttons until synchronization is complete.

6.15 Restoring to Factory Default

To restore the console to factory default, press and hold the up key for 30 seconds. The console will

beep and reset. Wait several minutes for the remote sensor to synchronize.