Specifications

Figure 2

Replace the battery door, and fold out the desk stand and place the console in the upright position.

Figure 3

2.4 Sensor Operation Verification

Verify the indoor and outdoor temperature match closely with the console and the remote thermometer

in the same location (about 5’ apart). The sensors should be within 4°F (the accuracy is ± 2°F).

Allow about 30 minutes for both sensors to stabilize.

3. Remote Sensor Installation

It is recommended you mount the remote sensor on a north facing wall, in a shaded area. Direct

sunlight and radiant heat sources will result in inaccurate temperature readings. Although the sensor is

water resistant, it is best to mount in a well protected area, such as an eve.

Use a screw or nail (not included) to affix the remote sensor to the wall, as shown in Figure 4.