User manual

2. Confirm your station ID is correct. The station ID is all caps, and

the most common issue is substituting an O for a 0 (or visa

versa). Example, KAZPHOEN11, not KAZPH0EN11.

3. Make sure your time zone is set properly. If incorrect, you may be

reporting old data, not real time data.

4. Check your router firewall settings. The ObserverIP sends data

via Port 80.

Only the Power, Link

and ACT lights are lit

and the ObserverIP

module does not

communicate to the

server.

The firmware will need to be reloaded.

1. Download the latest firmware here:

http://www.AmbientWeather.com/observerip.html

2. Power down the ObserverIP module but leave connected to your

router.

3. Launch the IP Tools application as referenced in Section 5.7.

Since the module is powered down, you will not be able to locate it

on your network, but proceed anyway.

4. Select the Upgrade button.

5. Reference Figure 33. Select the Select File button, and browse to

the location of the file you downloaded in Step 1.

6. Select the Upgrade Firmware button.

7. Plug in the ObserverIP module. The software will locate the device

on your network and begin the update.

Reference Figure 34. The dialog box will display Received a

Read Request from the ObserverIP module. A green progress bar

will provide you with the upgrade status.

DO NOT OPERATE THE MOUSE OR KEYBOARD WHEN

UPGRADING to prevent interruption of the upgrade.

8. Once the firmware upgrade is complete, the dialog box will display

Read session is completed successfully, as shown in Figure 35.

9. Wait about one minute for the ObserverIP module to reboot. You

can now Exit the upgrade window, and access the module again, as

referenced in Section Finding the ObserverIP from your computer

All of the lights should be on except the Server light (you will need

to reprogram the Wunderground.com settings).