User's Manual

Table Of Contents

Figure 5

1. Temperature

2. Min/Max Record mode

3. Temperature, Rate of Change indicator

4. Temperature units (°F or °C)

5. Humidity, Rate of Change indicato

6. Relative Humidity (%)

7. Humidity Comfort Icon

8. Reception Icon (solid when searching, flashes when updating)

9. Channel 1,2,3,4,5,6,7,8, indictor

2.4.2 Sensor Operation Verification

Verify the indoor and outdoor humidity match closely with the console and

sensor array in the same location (about 5 to 10' apart). The sensors should be

within 10% (the accuracy is ± 5%). Allow about 30 minutes for both sensors to

stabilize. The humidity can be adjusted or calibrated later to match each other a

known source.

Verify the indoor and outdoor temperature match closely with the console and

sensor array in the same location (about 5 to 10' apart). The sensors should be

within 2°F (the accuracy is ± 1°F). Allow about 30 minutes for both sensors to

stabilize. The temperature can be adjusted or calibrated later to match each

other or a known source.

3. Remote Sensor Installation

It is recommended you mount the remote sensor on a north facing wall, in a

shaded area. Direct sunlight and radiant heat sources will result in inaccurate

2 3