User's Manual

4.6.2 DisplayConsoleSetUp

Note: Power up the rain gauge, anemometer and thermos-hygrometer sensors first before

powering up the console. If you power up the console first, you will need to resynchronize the

sensors.

Make certain the weather station sensors are at least 10’away from the console and within

100’of the console. If the weather station is too close or two far away, it may not receive a proper

signal. If you have more than one thermo-hygrometer transmitter, make sure they are all powered

up and transmitting on different channels.

1. Remove the battery door on the back of the console, as shown in Figure 12.错误！未找到引用

源。2. Insert four AA batteries in the back of the display console. The display will beep once and

all of the LCD segments will light up for a few seconds to verify all segments are operating

properly. The console will cycle through a spectrum of colors.

Note: The character contrast is best viewed from a slightly elevated angle.