User's Manual

7.3 RestoreFactoryDefa ult

To restore the console to factory default, press the HISTORY/- key while installing the batteries

at the same time. Wait 3 seconds after installing the batteries to let go of the HISTORY/- key.

7.4 ChannelSelection

Press the CHANNEL/+ button to switch the display between remote sensors 1 through 8, and

scroll mode . In scroll mode, all of the indoor and detected outdoor sensors will be displayed

in five second intervals.

7.5 SensorSearchMode

If a sensor loses communication, dashes (--.-) will be displayed. If a specific channel is lost,

press the CH/+ button to display that channel prior to entering the search mode.

To reacquire the lost signal, press and hold the CH/+ button for 3 seconds to enter the sensor

search mode.

The icon REG will appear. You can synchronize one or all of individual sensors. Press the [+] or

[-] key to toggle between the following sensors:

• CH. Synchronizes Channel 1-8 Sensors (dependent on which channel is displayed before

entering the Sensor Search Mode*).

• WIND. Synchronizes Wind Sensor

• RAIN. Synchronizes Rain Sensor.

• ALL. Synchronizes All Sensors.

• NOT. Do nothing and exit the Sensor Search Mode.

After selecting one of the above options, press the SET key to relying, and the display will return

to normal mode. Do not press any buttons until the synchronization is complete. The remote

search icon

will display constantly for 3 minutes until the signal is reacquired.

7.6 HistoryGraphMode

The historical graph on the display changed to display the measured parameters.

In normal mode, press the HISTORY/- key to toggle between:

• the wind speed graph (the WIND icon is displayed)

• the rainfall graph (the RAIN icon is displayed)

• the barometer graph (the BAROREL icon is displayed)

• indoor temperature graph (the TEMP-IN icon is displayed)