User manual

1. Touch the outdoor temperature once, as shown in Figure 10. The outdoor temperature will

begin flashing and the + button and – button will be flashing (in the tendency section of the

display).

2. Outdoor Temperature, Wind chill and Dew Point. Touch the + button or – button to

alternate the display between the outdoor temperature, wind chill and dew point.

3. Outdoor Temperature Units. Touch the + button or – button to alternate the display unit

between ℃ and ℉ (press the outdoor temperature again if you wish to skip this setting).

4. Outdoor Temperature High Alarm. Touch the OUTDOOR TEMPERATURE section

again to set the outdoor temperature high alarm function. The +, ON/OFF and – button

will be flashing, and HI AL (high alarm) icon will light up.

Touch the + button or – button to change the value, or hold the + button or – button for 3

seconds to rapidly change the setting.

Touch the ON/OFF button to select the alarm on or off (if the alarm is enabled, the

speaker icon will be turned on, indicating the alarm function has been enabled).

5. Outdoor Temperature Low Alarm. Touch the OUTDOOR TEMPERATURE section

again to set the outdoor temperature low alarm function. The +, ON/OFF and – button

will be flashing, and LO AL (high alarm) icon will light up.

Touch the + button or – button to change the value, or hold the + button or – button for 3

seconds to rapidly change the setting.

Touch the ON/OFF button to select the alarm on or off (if the alarm is enabled, the

speaker icon will be turned on, indicating the alarm function has been enabled).

6. Outdoor Temperature Record High. Touch the OUTDOOR TEMPERATURE section

again to display maximum outdoor temperature record since the last reset. The maximum

record will be flashing, and the MAX icon will light up. To reset, press the maximum

temperature value for 3 seconds, and the maximum value will be reset to current reading.

7. Outdoor Temperature Record Low. Touch the OUTDOOR TEMPERATURE section

again to display minimum outdoor temperature record since the last reset. The minimum

record will be flashing, and the MIN icon will light up. To reset, press the minimum

temperature value for 3 seconds, and the minimum value will be reset to current reading.

8. Repeat the above steps for wind chill and dew point.

5.3 Indoor Humidity