User manual

Version 1.1 ©Copyright 2010, Ambient LLC. All Rights Reserved. Page 3
1
Rain gauge mounting bracket
1
USB cable (L: 41”)
1
Easy Weather CD
3
1” nuts and bolts (long)
1
13/16” bolt (short)
1
½” set screw (long)
1
3/8”set screw (short) (Optional)
1
Upper pole (L: 12”)
1
Lower pole (L: 12”)
4
Zip ties
2
Hose clamps (2 ¾” diameter)
3.2 Recommend Tools
 Precision screwdriver (for small Phillips screws)
 Pliers
 Phillips screwdriver
 Flat blade screwdriver
 Tack (small) hammer or rubber mallet
 Compass or GPS (for wind direction calibration)
3.3 Sensor Assembly Set Up
1. Connect the wind cup assembly to either end of the anemometer mounting arm. Align the
holes, and fasten with long bolt and nut. Tighten with precision screwdriver while securing
the nut with pliers, as shown in Figure 1.
Figure 1
2. Connect the wind vane assembly to the other end of the anemometer mounting arm. Align the