User manual

3. Connect the anemometer assembly to the top mounting pole, align the holes, and fasten with

short set screw (optional) and long bolt and nut. Tighten with precision screwdriver while

securing the nut with pliers, as shown in Figure 3.

Note: This may be a tight fit – rotate the pole back and forth to shave off some of the

plastic, and use a small hammer to tap the top of the anemometer mounting arm while

securing the pole on a solid, flat surface. Use a piece of cloth or padding to dampen the

hammer and avoid damage to the anemometer mounting arm.

Figure 3

4. Connect the rain gauge with long set screw. Tighten with precision screwdriver, as shown in

Figure 4.

Note: There may be a slight “play” in the rain gauge and the screw may not be flush.

Do not force the screw.

Attach the rain gauge mounting arm to the upper mounting pole, at right angles to the wind

speed and wind direction assembly to avoid obstruction of rainfall.

Note: There are two mounting holes on the side of the rain gauge in the event you wish to

mount the rain gauge in a different location than the mounting arm