User manual

The following is a list of the individual alarm parameters that are set (in order):

1. Alarm hour

2. Alarm minute

3. Indoor temperature high alarm

4. Indoor temperature low alarm

5. Indoor humidity high alarm

6. Indoor humidity low alarm

7. Outdoor 1 (channel 1) temperature high alarm

8. Outdoor 1 (channel 1) temperature low alarm

9. Outdoor 1 (channel 1) dew point high alarm

10. Outdoor 1 (channel 1) dew point low alarm

11. Outdoor 1 (channel 1) humidity high alarm

12. Outdoor 1 (channel 1) humidity low alarm

Note: To prevent repetitive alarming of temperature, there is a 0.9 °F tolerance band. For

example, if you set the high alarm to 80.0 °F and silence the alarm, the alarm icon will continue to

flash until the temperature falls below 79.1 °F, at which point, the alarm will reset and must

increase above 80.0 °F to activate again.

Note: To prevent repetitive alarming of humidity, there is a 4% tolerance band. For example,

if you set the high alarm to 60% and silence the alarm, the alarm icon will continue to flash until

the humidity falls below 56%, at which point, the alarm will reset and must increase above 60% to

activate again.

6.4 Alarm and Command Key Beeper ON/OFF Mode

The beeper can be silenced for both alarms and key strokes.

In normal mode, press and hold the ALARM key for five seconds to toggle the beeper on or off

(depending on the current setting).

The BUZZON (beeper on) or BUZZOFF (beeper off) icon will appear in the time area for three

seconds. Press and hold the ALARM button again for five seconds to toggle the BUZZON or

BUZZOFF command.

7 Other Console Features

The following section describes additional features and display icons.

7.1 Moon Phase

The following moon phases are displayed based on the calendar date.