User manual

same location (about 5’ to 10’ apart). The sensors should be within 10% (the accuracy is ± 5%).

Allow about 30 minutes for both sensors to stabilize. The humidity can be adjusted or calibrated

later to match each other a known source.

Verify the indoor and outdoor temperature match closely with the console and sensor array in the

same location (about 5’ to 10’ apart). The sensors should be within 3°F (the accuracy is ± 2°F).

Allow about 30 minutes for both sensors to stabilize. The temperature can be adjusted or

calibrated later to match each other or a known source.

3 Remote Sensor Installation

It is recommended you mount the remote sensor outside in a shaded area. A north facing wall is

preferred because it is in the shade most of the day. Direct sunlight and radiant heat sources will

result in inaccurate temperature readings. Although the sensor is water resistant, it is best to mount

in a well protected area, such as under an eve. Use a screw or nail (not included) to affix the

remote sensor to the wall, as shown in Figure 7.

Figure 7

4 Display Features

4.1 Comfort Icon

The comfort icon is based on humidity ranges specified in Figure 8. The icon is displayed for

indoor humidity, remote channel 1 humidity and optional remote channels 2 through 8 humidity.

RH<45%

RH 45%~65%

RH >65%

Dry

Comfortable

Wet