Quick Start Guide

Apollo3 Blue Plus EVB Quick Start Guide
QS_A3P_1p00 Page 10 2019 Ambiq Micro, Inc.
All rights reserved.
5. Software Development Tools
The standard Segger J-Link debug interface is used on the Apollo3 Blue Plus EVB. Please install the latest
Segger J-Link software, and configure your preferred development IDE (Keil, IAR, or Eclipse) to use J-Link
debug interface.
Links to development tools that support Apollo3 Blue Plus:
▪
SEGGER J-Link Software (6.48b Beta or later): https://www.segger.com/downloads/jlink
▪ KEIL uVision 5 (MDK5.25 or later): https://www.keil.com/demo/eval/arm.htm
▪ New Keil Pack (Also used by Eclipse): http://www.keil.com/dd2/pack/#/third-party-download-dialog
▪ IAR Version (8.10.1 or later): https://www.iar.com/iar-embedded-workbench/tools-for-arm/arm-cortex-m-
edition/
▪ GCC 5.3.1: https://gcc.gnu.org
Regardless of preferred IDE, please install the Segger J-Link software. All of the above development
environments support J-Link, but you must have the latest J-Link software installed. Most alternate
development environments also are supported by J-Link.
Please refer to the AmbiqSuite Getting Started Guide (AMSDKGS) at https://ambiqmicro.com/wp-content/
uploads/2017/09/AMSDKGS-v1_1.pdf for more details on setting up development IDEs to use J-Link.