User Guide

3. Close the ADF cover by pushing it back down until it snaps into place.

Replace the Pad Module

The approximate use of the pad module is 20,000 scans. A replacement pad module is

provided and should be saved. Additional pads are available for purchase at

www.ambir.com/support/imagescan-pro-800-setup

Replace Roller

The approximate use of the roller is 100,000 scans. To replace the roller, do the following:

1. Open the ADF cover by pulling the cover open lever.

2. Remove the pad module by pinching both sides of the pad module and pull it out.

3. Install the new pad module by inserting the tabs on the module onto their slots on the

scanner.

4. Close the ADF cover by pushing it back down until it snaps back into place.

1. Open the ADF cover by pulling the cover open lever.

2. Remove the pad module by pinching both sides of the

pad module and pull it out.

3. Install the new pad module by inserting the tabs on

the module onto their slots on the scanner.

4. Close the ADF cover by pushing it back down until it

snaps back into place.