User`s guide

User’s Guide

Uncheck “Enable” to disable ActiveX filter.

• Filter Popup Windows

Check “Enable” to enable Popup Windows filter.

Uncheck “Enable” to disable Popup Windows filter

• Block Fragmented IP Packets

Check “Enable” to enable blocking Fragmented IP Packets.

Uncheck “Enable” to disable blocking Fragmented IP Packets.

"With this feature enabled, all packets are checked to determine if the packet contains a "fragment"

flag. If the flag exists, the CM will discard the packet. This feature is used primarily to protect against

any intruders/hackers from gaining access to the router or network." "Under certain conditions, this

feature may cause communication issues with other devices on the network and should be disabled. For

example, streaming media applications may fragment the packets depending on the encoding used for

the video stream. Depending on the encoding used for the clip, some or a majority of the packets will

become fragmented. For clips encoded at 300 Kbps, 66% of the packets are IP fragments, while below

100 Kbps there is no fragmentation.

• Firewall Protection

Check “Enable” to enable Firewall Protection.

Uncheck “Enable” to disable Firewall Protection.

• Access Routed Subnet Protection

Check “Enable” to enable Routed Subnet Protection.

Uncheck “Enable” to disable Routed Subnet Protection.

• Apply

Any configuration changes must be followed by “Apply” before changes will occur.

• Trusted Computers - Add

Specify MAC address for trusted computer and click “Add” to add it to the list.

• Trusted Computers - Remove

Select MAC address from trusted computer list and click “Remove” to remove it from the list.