User Manual

1. If the wrong code is entered more than 4 consecutive times,
the lock will go into a LOCKOUT mode for 5 minutes.
During this period the lock will be non-operative and will
beep every 5 seconds until the 5 minute lockout mode is up.
2. After 5 minutes you can try again with the correct code to open
the safe..
1. locate a pin-hole in back of lock body.
2. Remove battery from lock, and press few digits on the keypad
to drain all power from the lock.
3. Insert a paper clip or sharp needle into the hole and press down
4. while pressing down, insert the battery back to give power and
listen for a long wobbly beep sound.
Wrong code penalty lockout:
Resetting the lock:
page 2
page 3
1. Enter the manager code (default 1-2-3-4-5-6), hold down the
last digit (6) and listen for 2 beeps, keep holding and listen for 2
more beeps. (approx. 3 seconds after)
Press 1 to change the first user code, enter a new six-digit code twice.
Press 2 to change the second user code, enter a new six-digit code twice.
Press 3 to change the third user code, enter a new six-digit code twice.
Press 4 to change the fourth user code, enter a new six-digit code twice.
Press 5 to change the fifth user code, enter a new six-digit code twice.
1. Enter the manager code (default 1-2-3-4-5-6), hold down the
last digit (6) and listen for 2 beeps, keep holding and listen for 2
more beeps. (approx. 3 seconds after)
Press 9 to for time delay change mode: Now enter 00-59 minute
opening delay.
If you pressed 02 for 2 minutes delay, it will take 2 minutes for
the lock to open after entering the correct code.
Keypad will sound a beep every few seconds to remind you that the
lock is in a countdown timer to open.
To take it back to no delay, repeat the same steps and enter 00
for zero minutes.
Example for 5 minute time delay setting: (imagining our manager
code is 445598)
1. Enter 445598 and keep holding the 8 for 3 seconds until you heard
two sets of 2 beeps.
Press 9 (time delay mode) followed by 05 (5 minutes). DONE
Resetting the time delay back to NO DELAY: (imagining our manager
code is 445598)
1. Enter 445598 and keep holding the 8 for 3 seconds until you heard
two sets of 2 beeps.
Press 9 (time delay mode) followed by 00 (0 minutes). DONE
1. Enter 0 six times, and then enter the existing code
(Initial factory code: 1-2-3-4-5-6)
Now enter your new 6-digit code twice.
YOUR NEW MANGER CODE IS NOW SET.
This code can be used to change user codes, functions and
to open the safe.
Changing the manager code:
Time Delay setting:
Changing any or all of the user codes: