Operation Manual

- 51 -
C141501700.fm
User's manual
GB
The robot is very
noisy
Damaged cutting blade
Replace the blade with a new
one (see "Replace the blade")
Cutting blade flooded by
residues (tapes, ropes,
plastic fragments, etc.).
Stop the robot in safety condi-
tions (see "Robot safety stop")
Caution
Use protection gloves to
avoid the risk of cuts on
hands.
Remove the flood cause from
the blade.
The start of the robot oc-
curred with obstacles
being too close (less than
m away) or in presence
of unexpected obstacles
(fallen branches, forgot-
ten objects, etc.).
Stop the robot in safety condi-
tions (see "Robot safety stop")
Remove the obstacles and re-
start the robot (see "Manual
startup and stop of robot (in
closed areas)")
Electrical motor malfunc-
tion
Get the motor repaired or re-
placed by the nearest authori-
zed Assistance centre.
Grass too high
Increase the cutting height
(see "Adjusting the cutting
height")
Carry out preliminary cutting
of the area with a normal lawn
mower.
The robot does not
position itself cor-
rectly inside the re-
charging station
Erroneous position of the
perimeter wire or re-
charging station power
supply cable.
Check the conneciton of the
recharging station (see "In-
stallation of recharging sta-
tion and transmitter-power
supplier group")
Ground subsidence near
the recharging station
Position the recharging sta-
tion on a flat and stable surfa-
ce 8see "Equipment
installation planning")
The robot behaves
in an anomalous
manner around
the flower beds.
Perimeter cable incor-
rectly placed.
Relocate the perimeter wire
correctly (anticlockwise direc-
tion) (see "Perimeter wire in-
stallation")
The robot works at
erroneous times
Wrong clock setting
Reset the robot clock (see
"Programming mode")
Wrong work timetable
setting
Reset the work timetable (see
"Programming mode")
The robot does not
carry out rapid re-
entry
Rapid re-entry not cor-
rectly set
Check the exact setting of the
rapid re-entry (see "Setting
for rapid robot re-entry into
the recharging station")
Problem Causes Solutions