Specifications

PAGE 7AMC+ SERIES INSTALLATION AND OPERATION MANUAL

OUTPUT DISTANCE WIRE SIZE

AMC+120P / AMC+1202P AMC+250P AMC+460P

100V

Up to 50m AWG24(0.2mm2) AWG22(0.35mm2) AWG26(0.12mm2)

50m–200m AWG18(0.75mm2) AWG16(1.5mm2) AWG20(0.5mm2)

Over 200m AWG16(1.5mm2) AWG13(2.5mm2) AWG18(0.75mm2)

70V

Up to 50m AWG22(0.35mm2) AWG18(0.75mm2) AWG24(0.2mm2)

50m–200m AWG16(1.5mm2) AWG13(2.5mm2) AWG18(0.75mm2)

Over 200m AWG13(2.5mm2) AWG10(6.0mm2) AWG16(1.5mm2)

4 OHM

Up to 10m AWG18(0.75mm2) AWG18(0.75mm2) AWG18(0.75mm2)

10m–30m AWG13(2.5mm2) AWG13(2.5mm2) AWG13(2.5mm2)

Over 30m Not Recommended Not Recommended Not Recommended

NOTE: Only connect one output – either Distributed Line or Low Impedance.

LINE OUTPUT

The LINE output XLR can be used to connect up to 6 booster ampliﬁers. Balanced wiring

(shielded pair cable) is recommended.

NOTE: When wiring the LINE output as unbalanced, pin 2 should be wired as hot and pin 1

should be wired as ground/shield. Do not wire pin 3.

INPUT CONNECTIONS

For wiring balanced in, pin 2 is hot.

Balanced input wiring (shielded pair cable)

is recommended. Unbalanced RCA wiring

should be keep as short as possible.

DIRECT OUTPUT

The output terminal strip accepts wire sizes from 16-22AWG (1.5mm2 –

0.35mm2) or spade lugs. The following table should be used as a guideline

for cable sizes. Regulations in your area may require different gauged wire

and should be checked before using.

INSTALLATION