User manual

Digital Monitor AMC-1DBx Series User Manual
101
The Zone Alarm/Fail message will appear when alarm or failed relay associated with a zone is active or
inactive. The zone number is 1-128 and the alarm level is 1-3 and sensor number can be 1-988. The Zone
Alarm/Fail message contains the following formats:
Zone:<Zone #> Alarm<Level> Sensor:<Sensor #> <Active or Inactive>
Zone:<Zone #> Fail Sensor:<Sensor #> <Active or Inactive>
Other possible Alarm log file messages:
Dew Point Alarm ambient temperature Sensor:<Sensor #> Active
Dew Point Alarm surface temperature Sensor:<Sensor #> Active
Dew Point Alarm relative Humidity Sensor:<Sensor #> Active.
Additionally the Alarm log tracks detail of the DIP Switch User Options when change is detected:
DIP Switch Audio:<Disabled or Enabled>
DIP Switch Sensor Delay:<Disabled or Enabled>
DIP Switch Minimum Run Time:<Disabled or Enabled>
DIP Switch Post Run Time:<Disabled or Enabled>
DIP Switch Calibration Mode:<Disabled or Enabled>.
APPENDIX A.4 SYSTEM.LOG Items
The system log file messages can appear in the USB Storage device when the menu item Log File>System
is enabled.
The System Log displays the following messages associated with BACnet:
AMC-1DBx BACnet Name
GNU SourceForge BACnet Stack Version 0.5.7
Max APDU: 1476
BACnet BIP Device ID: 677003
The System Log displays the Buzzer messages similar to ALARM.LOG items:
Buzzer Activated for Checking Data Base
Reset Cause Cleared by Hold Pushbutton
Buzzer Activated
Buzzer Activated for Silence Pushbutton
Buzzer Activated for RESET_RELAY Pushbutton
Buzzer Activated for System Failure
Buzzer Activated for Sensor Alarm
Buzzer Activated for Device Failure
Buzzer Activated for Test Pushbutton
Buzzer Cleared
System Failure Cleared
Sensor Alarm Cleared
Device Failure Cleared
Test Pushbutton Cleared
Data Base Failure Cleared
The System Log displays the system tasks as they are created. Below is a list of task creation message that
appear at start up (due to start up sequence not all messages are displayed in System log file):