User manual

Digital Monitor AMC-1DBx Series User Manual
31
5.1.5 AMC-1D-8R
4 HOLES
(12.996")
(9.65")
(Ø0.375")
330 mm
245 mm
Ø9.5 mm
Figure 5-5: Location of Mounting Holes for AMC-1D-8R
5.1.6 TRANSMITTER/SENSOR MOUNTING
Mount the sensor/transmitter on a solid, non-vibrating surface or structure in an area
where the ambient concentration of gas is not directly affected by the presence of clean
air supply, ventilation systems, or blockage by surrounding articles and sources of
interference gases. Please, refer to local codes for sensor/transmitter installation
information. The installer is required to provide any mounting hardware that may be
required. The recommended mounting height is specified in the SENSOR MODULE(S)
SPECIFICATION. The conduit entry is from bottom of box to avoid moisture flow into
box through conduit.
5.2 WIRING
5.2.1 Monitor Wiring
WARNING
ENSURE TO TAKE ALL RELEVANT SAFETY PRECAUTIONS WHEN
HANDLING HIGH VOLTAGE POWER SOURCES.
POWER
SUPPLY:
The monitor is available with either 120 VAC, 60 Hz or 24V AC/DC powering
options. A terminal block is provided for the power entry connections.