User manual

Digital Monitor AMC-1DBx Series User Manual
47
6.12.2 LOGGING IN
Entry into System Setup mode is gained by pressing the ENTER pushbutton while in any
Display mode.
To log into the monitor
1. Press the ENTER pushbutton.
The Log In screen is displayed.
2. Press the ENTER pushbutton again.
The Enter password screen is displayed.
3. Enter the valid 4-character alphanumeric password.
4. Press ENTER.
The Select Sensor menu item is displayed.
The default password is 1234.
Each digit of the password is blanked while the ensuing (following) digits are being
entered.
Note:
Until a correct password is used to log into the product application, setup data
may be viewed but not changed. The user password shall be changeable only
after you have logged-in using a valid password.
6.12.3 Changing Password
Once logged-in, you can choose to change the 4-character alphanumeric password.
To change the password
1. Log into the gas monitor.
2. At the Log In screen, press ENTER.
3. Enter the valid 4-character password.
4. Press ENTER.
The Select Sensor menu item is displayed.
5. Press the DOWN pushbutton.
The Select Relay menu item is displayed.
6. Continue pressing the DOWN pushbutton until the Change Password screen is
displayed.
7. Press ENTER.
The New Password screen is displayed.
8. Use the UP pushbutton to set the new password to the 4 alphanumeric
characters you want and press ENTER.
The Exit Setup screen is displayed.