User manual

Digital Monitor AMC-1DBx Series User Manual
50
• current gas concentration reading
• engineering units assigned
The bottom first line contains the Sensor number; a check mark indicates the Sensor
does not have a conflict in the system. A conflict can occur due to duplicate instance or
MODBUS addresses assignments. The second line of bottom displays the target gas
and current gas concentration with engineering unit assigned.
The middle sensor status area is similar to below and may contain status with N/A (Not
Available); these items indicate future features not currently available:
AMC
-1DB Gas Monitor 1.0
Display Log
Sensor3 Good, No Alarms
Remote MODBUS:1 Admin. Enabled
MODBUS Address:003 Instance:1
Type: AMC411
Number of Alarms:2
Alarm1 Relay:1 Delay:0s
Alarm2 Relay:2 Delay:0s
Alarm3 Relay: Not Used
Fail Relay:4 Delay:0s
Sensor Model: N/A
Sensor S/N: N/A
Calibration Period Days: N/A
Days before Calibration: N/A
Days before End of Life: N/A
Sensor Supply Voltage: N/A
Sensor Temperature: N/A
---------------------------------
SensorStatus:√S#003
CO 0 PPM
To access the Get Sensor Status menu
1. At the Log In screen, press the DOWN pushbutton.
The Set Options screen is displayed
2. Press the DOWN pushbutton.
The Select Sensor screen is displayed.
3. Press the DOWN pushbutton.
The Select Relay screen is displayed.
4. Press the DOWN pushbutton.
The Get Sensor Status screen is displayed.
Get Sensor Status
Press ENTER and navigate to the sensor number and press another ENTER to display
sensor information.