User manual

Digital Monitor AMC-1DBx Series User Manual
51
6.12.8 GET RELAY STATUS
The Get Relay status display allows you to view operational status and statistics about
the relay in question. It is available when system is running with Option/Menu Display
Mode is set for Disp All Relay or through the logged out menu; Get Relay Status.
The bottom two-line display is employed to navigate to the relay status window. The
bottom two-line display indicates;
Line 1:
• menu item title
• relay number
• a check mark (√) indicating the relay ID is unique within the system
• Alarms count indicating the number of sensor or zone sensor device(s)
associated with the current relay state.
Line 2:
• Relay state.
The bottom two lines of the relay status have shortened relay state items when
necessary. The bottom first line contains the Relay number with Alarm Counts; a check
mark indicates the Relay does not have a conflict in the system. A conflict can occur due
to duplicate instance or MODBUS addresses assignments. The second line of bottom
displays the following information with shortened items in bold:
• Power-On delay, Not Found,
• Energized(Ene) and De-Energized(De-Ene) associated with or without a Zone
Event (ZE),
• Energized(Ene) and De-Energized(De-Ene) Pending(Pend) associated with or
without a Zone Event(ZE),
• Energized(Ene) and De-Energized(De-Ene) Latched associated with or without
a Zone Event(ZE),
• Energized(Ene) and De-Energized(De-Ene) Minimum Run Time(MRT)
associated with or without a Zone Event(ZE),
• Energized and De-Energized Post Run Time(PRT) associated with or without a
Zone Event(ZE).
The middle relay status area is similar to below and carries two forms (Remote and
Local items):