User manual

Digital Monitor AMC-1DBx Series User Manual
60
The submenu items listed have various choices selectable with Up and Down
pushbuttons. Choice is selectable by the Enter pushbutton, which advances you to the
next item. The Previous pushbutton moves you up the hierarchy.
Note: The √ found in the display indicates sensor, relay or analog output is unique. A
unique device is one that is not duplicated within systems, address, interface, and
instance configuration.
The 

( down-arrow) located between the display items indicates that the user must press
the ENTER pushbutton to drill-down to the next submenu item.
To access the Select Sensor menu
1. Log into the gas monitor.
2. At the Log In screen, press ENTER.
3. Enter the valid 4-character password.
4. Press ENTER.
The Select Sensor menu item is displayed.
Table 6-1 describes the submenu items found in the Select Sensor menu.
Table 6-1: Select Sensor Submenu
SUBMENU DESCRIPTION DISPLAY
Select Sensor
Set Sensor Admin
State
Select Sensor Label
Allows the selection of the sensor of
interest for displaying the sensor
configuration. (1-988)
Shows the selection of the sensor admin
state. (Enable/Disable)
Shows the selection of the sensor label.
(See Appendix of gas types)
Select Sensor
1

Sensor Admin √S#001
Enable

Existing Label√S#001
CO

Sensor Interface Shows the selection of the sensor
interface.(MODBUS 1-4)
Sen Interface √S#001
Modbus1

Sensor Address Shows the selection of the sensor
address. (1-247)
Sen Address √S#001
89

Set Instance Shows the selection of the sensor
instance. (1-4)
Sen R Instance√S#001
4

Set Location Label
(Optional)
Shows the setting of the location label.
(If option configured from Option menu)
Location Label√S#001
L1

Set Engineering Shows the setting of the engineering
Eng. Units √S#001