User manual

Digital Monitor AMC-1DBx Series User Manual
67

Select Sensor Shows the selection of the sensors
associated to the defined zone. Up to
128 sensors may be associated with a
zone, which are stored in the IDs
indicated by the S#. Consecutive IDs can
be filled or blanked for a range starting at
S#. (ID001-ID128,QUIT)
The display’s middle area shows the
current 128 IDs for the zone (see the
following example).
AMC
-1DB Gas Monitor 1.0
Display Log
001,002,003,004,005,006,007,008
009,010,011,012,013,014,015,016
017,018,019,020,021,022,023,024
025,026,027,028,029,030,031,032
033,034,035,036,037,038,039,040
041,042,043,044,045,046,047,048
049,050,051,052,053,054,055,056
057,058,059,060,061,062,063,064
065,066,067,068,069,070,071,072
073,074,075,076,077,078,079,080
073,074,075,076,077,078,079,080
081,082,083,084,085,086,087,088
089,090,091,092,093,094,095,096
097,098,099,100,101,102,103,104
105,106,107,108,109,110,111,112
121,122,123,124,125,126,127,128
---------------------------------
Zone Sensors Z#128
ID001 for:001 @ S001
Zone Sensors Z#001
ID001 for:001 @ S987

Select Relay Shows the selection of the relays
associated with each zone’s alarms.
(Alarm1 Relay, Alarm2 Relay, Alarm3
Relay, Fail Relay) Note: Actual activation
of Alarm Relays is dependent on the
sensor’s No. of Alarms setting.
Zone Relays Z#001
Alarm1 Relay

Shows the selection of the zone
associated to an Alarm/Fail Relay.
(1-256)
Alarm1 Relay Z#001
1

Select Analog
Output
Shows the selection of the zone
associated to an analog output. (1-128)
Zone AnaOut Z#001
128