User manual

Digital Monitor AMC-1DBx Series User Manual

6.12.17

SET INTERFACE

The Set Interface menu is the top level menu item used to configure the digital interfaces

for the monitor. See Figure 6-5.

From this top level you can navigate to configuration menus for the following interfaces:

• RS-485 interfaces facing downstream to the MODBUS slave devices

(transmitters, relay modules and annunciators)

• RS-485 interface facing upstream to the BAS

• Ethernet/IP interface to the attached LAN (see Set IP Configuration)

• BACnet interfaces to the BAS (see Set BACnet Configuration)

• MODBUS interface facing upstream to the BAS (see Set MODBUS Configuration)

• Analog outputs (Set Analog Out)

RS-485 Port

Set Parity

Set Character Length

Set Baud Rate

Select Port

Set Stop Bits

Set Type

Port 1,2,3,4 – RTU or ASCII

Port 5 – RTU or BACNET MS/TP

<ENTER>

Ports 1-4

<DOWN>

Set Administrative State

<Enter>

Port 5

Figure 6-5: Set Interface (RS-485) Menu