User manual

Digital Monitor AMC-1DBx Series User Manual
74
6.12.18 SET IP CONFIGURATION
The AMC-1DBx digital monitor contains one 10/100baseT Ethernet power. The monitor
supports the IP protocol over this interface. The IP protocol is required to support
BACnet/IP, MODBUS TCP, web and telnet services.
The IP protocol requires the following configuration items to enable successful
communications:
• IP Address
• Subnet mask
• Router IP Address
The Set IP Configuration submenu is displayed in Figure 6-6. This submenu is accessed
from the Set Interface menu.
Set IP Configuration
Set IP Address
Set Router IP Address
Set Subnet Mask
<DOWN>
<ENTER>
Figure 6-6: Set IP Configuration Submenu
To access the Set IP Configuration submenu
1. Log into the gas monitor.
2. At the Log In screen, press ENTER.
3. Enter the valid 4-character password.
4. Press ENTER.
The Select Sensor menu item is displayed.
5. Press the DOWN pushbutton until the Set Interface submenu is displayed.
6. Configure the Set Interface submenu items as necessary.
Once the configuration of the Set Interface submenu items is completed, the
IP Configuration submenu is displayed.
Table 6-6 describes the items found in the Set IP Configuration submenu.