User manual

Digital Monitor AMC-1DBx Series User Manual
94
• DIP Switch Changed Detected Old:0xD0 New:0x90
• DIP Switch bits:LANGB,LANGA,PRT,CAL_MODEn,MRT,ZERO_BUFFER,SENSOR_DELAY
This occurs when a user mode dip switch change is detected. The initial value will also be display unless
equal to 0x00. The Admin and Alarm logs will also display details related to specific bits decode.
• Network Updated from Data Base
The “Network Updated from Data Base” message will also appear when the IP configuration has been
changed. The Network is only updated when change activity ceases for a period of 30 seconds.
• No Sensors Available
The “No Sensors Available” will appear when system is currently running with no sensors discovered
and can occur briefly at system start. This message may also be displayed when no sensors have been
configured in the data base.
• USB Device Plugged In
• USB Stick Ejected from Menu
• USB Device Unplugged
The “USB Device Plugged In” or “USB Device Unplugged” messages will appear when USB storage
device is inserted or removed. The “USB Stick Ejected from Menu” message will appear when the USB
device is un-mounted through the menu; this will ensure all existing log messages are flushed to their
appropriate log file and closed.
• USB Format Selected from Menu
• USB Format Skipped Device Ejected
• USB Format Complete
The “USB Format Selected from Menu” message will appear when built in USB Storage formatting
facility is performed. The message “USB Format Complete” is logged upon successful USB format. This
USB formatting can be quite lengthy and can be alternatively performed on any PC platform in less time.
The message “USB Format Skipped Device Ejected” will be displayed if the USB device is not
detected upon format request.
• FLASH Upgrade: Need to Reboot to re-initialize NANDFLASH Driver and start new image
The “FLASH Upgrade: Need to Reboot to re-initialize NANDFLASH Driver and start new image”
occurs at system start up when FLASH F/W upgrade is complete. The FLASH F/W can be upgraded
when the 10Aquila.elf.bin and 10Aquila.elf.csum files are detected at start up on the USB Storage
device. Further log details about FLASH Upgrade can be found in the system log file when enabled.
• No USB Device to Save DB
• Database Saved to USB <Filename>
• Database+ Saved to USB <Filename>
The “No USB Device to Save DB” message will appear if there is no USB device present when the data
base save is activated. Data base save is activated when user logs off the menu system. A message
similar to “Database Saved to USB c:\amc-1db.adf_saved_2013_8_27_10_45” and “Database+
Saved to USB c:\amc1db_P.adf_saved_2013_8_27_10_45 will appear upon completion if the USB
storage device is present.
• Display Logging suspended during remote AMC Manager activity
• Console Logging suspended during remote AMC Manager activity