User manual

[EN] English - K0461 issue 1 Quick Reference 5

Quick Reference

WARNING: Before using this instrument, read and understand the “Safety”

section. It is dangerous to ignore the specified warnings.

Start operations (S1 to S4)

S1: Install the battery. Refer to Section 5.

The battery pack [a] (part number: IO620IS – Battery)

will be partly changed, it is recommended to fully

charge the battery pack before using the instrument:

• Connect the charger [b] (part number:

IO620IS-Charger) to a power supply.

• Connect the charger to the cradle [c] (part

number: IO620IS-Cradle).

• Correctly insert the battery into the cradle (making

sure the battery pack label faces upwards).

• The battery charger LED [d] indicates the different

charge states. When the LED shows green the

battery pack is fully charged and ready to use. The

battery pack takes approximately 8 hours to fully

charge.

S2: Power on/off sequence.

Note: The instrument can also be put in stand-by mode (deep sleep mode). Stand-by mode can

only be initiated when the instrument is ON (i.e. normal output). Press and hold of the ON key for

1 sec to go into stand-by mode. To turn the instrument ON press the ON key for 1 sec. The

instrument will return to the last mode that it was configured. It is not recommended to keep the

instrument in stand-by for long periods of time (100hrs max) to preserve battery capacity.

First display Wait Normal output

OFF

Press and hold

First display

for

DPI 620-IS CE

First display for

DPI 620-IS

Press and hold

for 3 seconds

[a]

[b]

[c]

[d]