User`s manual
Table Of Contents
- Notices
- Introduction
- Installing AMC and Decoders
- Install AMC
- Remove AMC (Windows 2000, Windows 2003 Server, and Windows XP)
- Remove AMC (Windows Vista, Windows 2008 Server, Windows 7)
- Install AAC Decoder
- Remove AAC Decoder
- Install MPEG-4 Decoder
- Remove MPEG-4 Decoder
- Install H.264 Decoder
- Remove H.264 Decoder
- Install Windows Media Format Runtime
- Install Desktop Experience (Windows 2008 Server)
- Toolbar Controls in Live View
- AMC Control Panel
- General Tab
- Network Tab
- Streaming Tab
- Snapshot Tab
- MPEG-4 Tab
- H.264 Tab
- Video Tab
- Audio Tab
- PTZ Tab
- Recording Tab
- AXIS T8311 and AXIS 295 Video Surveillance Joysticks
26
AXIS Media Control - PTZ Tab
Configure Buttons - Click on Configure Buttons to bring up the Buttons Configuration menu. Your Axis joystick has a
certain numbers buttons that can each be programmed to perform one of several different functions. See Joystick button
configuration below for more information.
Note: See AXIS T8311 and AXIS 295 Video Surveillance Joysticks, on page 30 or for a description of the joysticks and their parts.
Mouse Settings
Use this setting to adjust the zoom speed when scrolling with the mouse wheel.
Miscellaneous
Set AMC to start in either Emulated Joystick Mode or Center Mode.
The default setting for PTZ is the Center Mode. When in Center Mode, click on any part of the image other than its exact
center and the camera will move so that the point you clicked on becomes the new center of the image.
If you select Emulate Joystick Mode and refresh your screen, the camera moves in the direction of the mouse pointer. If you
click and hold down on the left mouse button, and then point to the lower left hand corner of the image, the camera
continues to move left and down until you release the mouse button.
Select Enable PTZ Overlays to show the graphical overlays that normally appear in the image when viewing your camera on
the Live View Web page. PTZ Overlays will only be visible when Enable Overlays is selected in the Video tab. See Video Tab, on
page 23.