User Guide

Controller Object Commands
www.3ware.com 29
/c x show serial
This command reports the serial number of the specified controller /cx.
Example:
//localhost> /c0 show serial
/c0 Serial Number = F12705A3240009
/c x show pcb
This command reports the PCB (Printed Circuit Board) version of the
specified controller /cx.
Example:
//localhost> /c0 show pcb
/c0 PCB Version = RevX
/c x show pchip
This command reports the PCHIP (PCI Interface Chip) version of the
specified controller /cx.
Example:
//localhost> /c0 show pchip
/c0 PCHIP Version = 1.x
/c x show achip
This command reports the ACHIP (ATA Interface Chip) version of the
specified controller /cx.
Example:
//localhost> /c0 show achip
/c0 ACHIP Version = 3.x
/c x show numdrives
This command reports the number of drives currently managed by the specified
controller /cx. This report does not include (logically) removed or exported drives.
Also note that physically removed disk(s) will not be detected unless I/O is
performed against the disk. See “/cx/px show smart” on page 71 for a workaround.
Example:
//localhost> /c0 show numdrives
/c0 Number of Drives = 5