User manual

positioning the dehumidifier there and moving it to a more central location at a

later date. For the most effective use, run your dehumidifier with external

doors and windows kept closed. Please note the unit should not be placed

directly against a radiator or other heat source.

When positioning your AMCOR dehumidifier, ensure that it is placed securely

on a level surface clear of any obstacle that may limit the air movement.

The dehumidifier can be wall mounted with the optional bracket set. Only use

original brackets specially designed for the unit.

This dehumidifier is designed only for indoor residential / office applications

and any commercial or industrial use will invalidate the warranty.

Place the dehumidifier on a flat dry surface.

The dehumidifier must be operated in an enclosed area to be most effective.

Close all doors, windows to create the best operating environment.

Do not use outdoors.

Water Drainage

When the water tank is full, the unit will stop automatically. When this

happens the water full indicator light will show on the control panel.

There are two ways to dispense collected water.

Use the tank. When the tank is full, the unit will automatically stop running,

and the Full indicator light will flash. Slowly pull out the tank. Hold the

bottom of water-tank to pull it out by recessed handle. Remove the tank cover

only before emptying it. Empty the water tank and reinsert it into the

dehumidifier. The tank must be in place and securely seated for the

dehumidifier to operate again. The dehumidifier will re-start when the tank is

restored in its correct position.

Notes:

• Do not remove the water tank immediately after the unit stops. Please

wait a while to avoid the water dripping into the unit and causing damage.

• Only empty the water tank when is full or before moving or storing the

unit.

• Do not rest the tank on the floor because the bottom of the tank maybe

uneven and tank will fall and cause the water to spill.

• When you remove the bucket, do not touch sensors or any parts which are

situated behind tank. Doing so may damage the product. Be sure to push the

tank gently all the way into the unit. Banging the bucket against anything or

failing to push it in securely into place may cause the unit not to operate.

• Do not remove or damage the float switch in water-tank, otherwise the

machine will stop working.

• Please make sure the water tank cover is put back into place correctly

before the water tank is reinserted.