User manual

Setting the Dehumidification level

Press dehumidify level key to select Low / Medium / High level.

Corresponding indicator turns on the humidistat set range for this

unit from 70%, 60% and respective 50% RH.

Use the unit on Low mode for maximum power savings with a target

humidity below 70% RH. Medium settings will ensure good humidity

level below 60% RH with less power being used. High mode ensure

a target humidity of 50%RH while the humidistat ensure that the air

will not get too dry.

Laundry mode is set to a 40% RH while the power consumption is

reduced to a spectacular for a desiccant dehumidifier 260 Watts.

Recommended humidity for human habitation is between 50-60%

RH.

Intelligent dehumidification and power saving

Your Amcor dehumidifier features an intelligent micro CPU that

ensure maximum water extraction with minimum power use.

Once the desired set humidity was been achieved the

dehumidification cycle will stop for 30 minutes unit going in to a

standby mode. At the end of the sleep period the dehumidifier will

wake up for 5 minutes in fan mode to measure the humidity in the

air. If humidity is higher than target humidity the unit will start

working until the desired humidity is achieved. This process ensure

maximum power savings while maintaining the desired humidity.

Setting the Ioniser

Press IONISER key on / off. Ioniser will sterilise the air preventing

mould growth and improving air quality.

Operational Advice

Plug to power, press ON/OFF key to turn-on the machine; press

ON/OFF key again to turn-off the dehumidifier.

Make sure water-tank is placed/ fitted correctly. If the water tank

is not fitted/placed correctly the 'water full' light will turn on and

the machine will not operate.

When the dehumidifiers first starts, default dehumidify setting is

set to “LOW “.