Operation Manual

9
Air flow
On the moment the air conditioner is connected to the mains, the louvres open and
close and stay closed.
• When the ON-button is pressed, the louvres open to maximum and return to an
angle of 75° above the upper plane of the louvres housing.
• Press the
-button, the louvres will swing continuously up and down between
30° and 80° above the upper plane of the louvres housing.
• By pressing the -button again the movement will stop and the louvres remain
in that position. The direction of the air flow is then constant.
• When the OFF-button is pressed, the louvres close.
This way of directing the air flow is particularly convenient when using the remote
control: a user friendly approach to your comfort.
In order to direct the air flow to a lower angle, raise the louvres housing by pulling it
up only by the centre of its back rim.
Sleep mode
The sleep mode function adjusts the set temperature of the unit to the thermal
needs of the body falling asleep as follow:
• Default fan speed: LOW
• Press the
Air outlet up,
louvres opened
Air outlet down,
louvres closed
Raising the
louvres housing.
GB
-button to operate the sleep mode. Press the -button again in order
to cancel the sleep mode.
The set temperature will increase 1°C after 1 hour and a further 1°C after 2 hours.
• No FAN mode under SLEEP mode operation.
Dehumidification
If the unit will be used mainly as a dehumidifier just let the warm air return in the
room.
Continuous drainage (see separate chapter) is then necessary and more
efficient.
Heater
This appliance has a 1680 W electric heater that can heat a room on cooler days.
With the mode button select , set the desired temperature and the unit will heat
until this temperature is reached. Fan speed is selected automatically. Do not place
the unit near anything that could catch fire or be scorched. Do not obstruct the air
outlet. The heat function will operate with or without the hose attached.