Quick Start Guide

11
The following setup processes will be shown using the NVR’s local interface. However, these
same steps can be done through the web interface on a computer. For more information on how
to access your device from a web browser, please refer to section, “Computer Access Setup”.
Despite the difference in appearance, the setting pages have similar organizational structures.
Enabling Recording Options
This menu should be verified to ensure that all recording protocols are enabled. This menu details,
per channel, which streams are enabled or disabled in the NVR. To access this menu, please refer
to the information provided below.
1. On the main menu, click on Storage.
2. Click on Record Mode. This menu displays all active channels and streams being used for
recording. If using snapshots, ensure the Snapshot radio button is enabled on each stream. To
apply the settings to all channels, click on the All radio button. Click Apply.
Setting Up Recording Schedules
1. From the Main Menu, click on STORAGE in the SETTING section:
Make sure you are on the SCHEDULE > REC page. This is where you can configure your video
recording schedules. To configure a snapshot schedule, click on the Snapshot tab. All video
events will be saved and accessible using the playback menu, if a hard drive is installed, by default,
Regular (24/7), MD (Motion Detection), and Alarm will be activated for all days as indicated by
the different colored bars available in this menu.