User Guide

31
3. Click on the “Send Email” checkbox. To enable the NVR to send an email once a motion is
detected.
4. Click on Apply to save the settings to your system.
Once you have set up your settings for one channel, you can copy them to other channels in the
system. If you did not select All after clicking Channel as previously described, click Copy,
select channels to copy to, then click Save.
Click Save to save all the settings made on this page. Click Apply in the Motion Detect menu to
finish saving your motion detection settings to your device.
Accessing Playback
Motion and general recordings can be accessed in the Playback option on the main menu. A
hard drive must be installed to access and view recordings from this menu. To access the
playback interface, click on the Playback option located in the main menu.
Please note, each NVR has its own capabilities in relation to the number of cameras it can
playback or support. Please refer to the specifications sheet for your specific device or for more
details on playback please visit amcrest.com/support.
To view recordings from the search menu, select the camera you wish to view from the Camera
Name section by clicking on a checkbox next to the device.