User Guide

10
5. Then, on the new window, change your resolution from 1280x1024 to 1920x1080. Once
complete, scroll down to the bottom and click on Save to save your display settings. Your DVR
will reset to effect the change.
6. Disconnect the VGA cable and connect your DVR to an HD monitor or TV using an HDMI cable.
Don’t forget to change the input to HDMI on your TV/monitor. The DVR will load and you will be
able to properly use the unit on your screen.
Hard drive installation
A hard drive allows you to configure and store recordings from the DVR, This includes playing
back previously recorded footage.
Note: This section only applies to DVRs purchased without a hard drive already preinstalled.
Most ‘kits’ or bundles will come with a pre-installed hard drive.
The DVR has connections for only 1 hard drive inside the case and the hard drive must be
no bigger than 6TB (Terabytes).