Manualshelf

User Guide

ManualsBrandsAmcrest ManualsElectronicsNV2104-HS 4CH NVR 4K/6MP/5MP/4MP/3MP/1080P Network Video Recorder, 4-Channels, No PoE Ports, Supports 4 x 4K IP Cameras, HDD Not Included (Supports up to 6TB Hard Drive) (No Built-in WiFi)
31323334353637383940
35
4. In the Network settings page locate the TCP/IP option on the left panel list. Then, locate where it
says IP Address on the main center page of the window.
5. Write it down. It will look something like ‘192.168.xx.xxx’, or ’10.0.XX.XXX’ depending on your
network, router, or service provider.
Note: It does not matter what your IP address looks like, however, the IP address is needed to
access the NVR from a web browser. If DHCP is enabled, it is highly recommended to disable it
to allow the device to maintain a static IP address. This will help to increase the overall efficiency
and security of your device.
Accessing the Web User Interface
To access the web user interface (web UI) for your NVR, open a web browser and type the IP
address for your NVR into the browser and press Enter. This will pull up the Device Initialization
screen. Set a location, language and video standard then click Next to continue.
Choose your Time Zone and System Time then click Next to continue.
Enter Password
Like accessing the NVR directly, if you are accessing the NVR for the first time you will need to
enter a password for the device. Enter a password. Click Next to continue.
Next, it is recommended to secure your NVR with an Email address and security questions. The
Email address entered can be used for password recovery purposes in case a password is
forgotten or needs to be reset.