User Guide

02
Physical
Installation
The physical installation of
your camera will involve the
following items.
SCREWDRIVER - A Phillips head screwdriver
will be needed to mount your camera.
DRILL - A drill may be required if installing
the camera on concrete, stucco, or a brick
mounting surface.
INSTALLATION POSITION MAP - This will be
included in the box and will provide a
template for the physical installation of your
camera.
WALL ANCHORS - Used to secure the
mounting screws into the mounting surface.
MOUNTING SCREWS - Used to mount the
camera to the mounting surface.
Installing the Camera
Place the installation position map onto the mounting surface and using a drill, drill the
marked holes. Place the wall anchors into the holes. Next, turn the mounting bracket in
a counterclockwise motion to remove it from the camera. Then, remove the bottom
bracket from the top bracket by twisting in a counterclockwise motion.
Place the bottom bracket onto the installation map aligning the holes to the wall
anchors. Secure the bracket using a Phillips head screw driver and mounting screws.
Place the camera back onto the security screw of the top mounting bracket and turn in
a clockwise motion to secure it to the camera. Place the top bracket back onto the
bottom bracket and turn in a clockwise motion to tighten and secure the camera to the
mounting surface.
Note: A 15/64’s drill bit may be required
to drill the holes for the wall anchors.