User Manual

Physical Installation

Before physically installation, please ensure the proper voltage is present in the area you are installing

the device. The voltage at the install sight should range between 16V~24V AC to function. If proper volt-

age is not available, it is highly recommended to contact a licensed electrican to complete the physical

installation of your device.

The Amcrest Wi-Fi video doorbell does not require a chime to function as long as adequate voltage is

being applied to the device. Please note, the Amcrest WiFi doorbell also does not require any special

resistors and/or diodes to function.For more information on how to install your device, please refer to the

information below.

Installing the Chime Kit

The Chime Kit, also known as a power kit, allows the doorbell to sync with your home’s existing chime

system. If you do not have a chime system, the chime kit is not necessary and you can proceed to the

physical installation of your doorbell.

Connect the Wire Harness

If the wire harness does not come preinstalled with the

included wiring. Use a precision screwdriver to open the

terminals on top of the connector and insert the wiring

into the ports. The red and black wires can be placed in

any position inside the connector, and tighten the

screws to secure.

Turn the Circuit Breaker Oﬀ

Since we will be working with electrical wiring, make sure to shut oﬀ the

power to your doorbell at the electrical breakers of your home to ensure

no power is ﬂowing through the internal doorbell system.

Remove the Cover for Your Chime

Your existing chime may look diﬀerent depending on if you

have a digital or mechanical chime.

NOTE: A Chime Kit is only needed for

systems with mechanical or electrical chimes.