User Manual

Installing the Wi-Fi Doorbell

Everything you need for the installation of your Amcrest Wi-Fi doorbell is included in the box,

however, a 15/64 masonry drill bit may be required if installing the device on concrete, stucco or

brick.

2. Use the included Philips

head screwdriver to remove

the bracket screw from the

doorbell.

1. Place your ﬁngers in the

indentations on the sides of

the doorbell, simultaneously

pull away and push the

faceplate out.

Remove the Faceplate and Bracket

2. Place the doorbell bracket to ﬁt your exist-

ing doorbell wiring. Then mark the drill holes

with a marker.

For Wood, Drywall or Soft Surfaces: Secure the

doorbell bracket to the mounting surface using the

included screwdriver and mounting screws.

For Concrete, Stucco or Brick: Using your previously

marked holes as a guide, drill holes into the mounting

surface using a 15/64 masonry drill bit. Then, insert

wall anchors and secure the mounting brackets using

the included mounting screws.

1. Remove your existing doorbell from the wall

and disconnect the wires. These are the wires we

will be using to install your new Amcrest Wi-Fi

Doorbell.

Installing the Mounting Bracket