User Manual

Connect Doorbell to Existing Wiring
Loosen the terminal screws
located on the back of your
Wi-Fi Doorbell using the included
Phillips head screwdriver. Place
your existing doorbell wiring
underneath the terminal screws,
then re-tighten the terminal
screws to secure the wires.
NOTE To attach the wires,
align the ends of the two
wires, place the wire nut
over the exposed wiring
and twist the wire nut
clockwise to tighten.
NOTE If your existing doorbell wiring
is too short, use the included extra
wires and wire nuts to extend your
wiring. Remove the terminal screws
completely then thread the screws
through the extra wire.
Inserting a MicroSD Card
(Optional)
On the side of the device locate the
MicroSD card slot. Raise the MicroSD
card flap and insert the MicroSD
card, gold pins down. Secure the flap
back to the doorbell.
Feed the wiring back into the wall. Then,
secure the doorbell to the mounting bracket
using the included screwdriver.
Mounting the Doorbell
NOTE Be sure to secure the the doorbell
correctly to the bracket lip, located at the top
at the mounting bracket.
Supports 128GB MicroSD Card (Class
10 or Higher)
128
GB
12