User Manual

14
Scan the QR Code
Scan the QR Code on the back
of the doorbell or manually enter
the serial number for the device
by tapping “Manually enter S/N”.
The serial number can be found
on the serial tag on the back of
the doorbell or on the side panel
of the doorbell box.
Connect to the Hotspot
Remove the protective plastic casing
from the doorbell and press the
reset/config button on the side of the
doorbell to enable the hotspot for
your device. If there is a blue spinning
light on the front of the device, it
means that the device hotspot is
properly turned on.
Tap “Next” to continue. Tap “ Yes” to
verify the hotspot has been properly
enabled.
Set a Password
Type in a password you
would like to use and
confirm it. Please use a
combination of letters,
numbers, and symbols
between 8 - 32 characters
long when setting up a
password.
Tap “OK” to continue.
Choose Your Wi-Fi Network
Select your Wi-Fi network from
the Wi-Fi network list. Enter the
password for your home Wi-Fi
network. If you would like to
save this password to the app,
tap on “Save Password”
Tap “Connect” to continue.
Note: If you have chosen the wrong Wi-Fi network and would like to select another Wi-Fi
network for the doorbell to connect with, tap on “Select other network”.
Once connected, the LED indicator
on the front of the doorbell will turn
solid blue. This may take a few
moments but if the LED indicator
continues to spin or the device is
reporting “Wi-Fi password is incor-
rect”. Tap on “Start Over” to try again.
Tap “Next” to continue
Connect to Your Device
Name Your Device
Rename your doorbell. A few
examples are provided such
as; Front Door, Back Door,
Office, and can be selected
if needed. After you have
finished naming your device,
tap on the save ( ) icon
to continue.