User Manual

Rear Panel
The rear panel of the device includes a microSD card slot, reset/config button, as well as power input
ports which act as a power terminal for your device.
Reset/Config Button
MicroSD Card Slot
Power Input Ports
Reset/Config Button
• The reset/config button will be used to establish an initial connection during setup. When
pressed the device will broadcast a hotspot connection which will be used to connect the
device to the mobile app. A blue spinning light will be represented on the indicator light
located on the front of your device.
• The reset/config button can also be used to factory reset your device. Performing a factory
reset will revert your device back to its original factory settings. To perform a factory reset the
device must be bound and deleted from your Amcrest Smart Home account. To perform a
factory reset, press and hold the reset/config button for 10 seconds and release, allowing the
device to reset. Once reset the indicator light on the front of the device will blink indicating the
device has been reset and ready to connect.
Power Input Ports
The power input ports are used to house the power cables and terminal screws for your device.
The device is compatible with a standard 16~24V AC or 12V~24V DC power adapter. A power
adapter is not included with the doorbell however can be purchased separately, either through
Amcrest or a third party source.
• With an AC 16V~24V power source the device can connect and function with a wired or
wireless chime (mechanical and electrical) using the included Chime Kit. Anything below the
recommended voltage level will result in the system not providing enough voltage to the
chime. This will cause the chime not to function properly with the doorbell. For a brief over
view of the wiring
6