080P Analog HDCVI Bullet Camera AMC1080BC36-B User Manual Version 2.0.
Contents Welcome................................................................................................................................................................ 3 Important Safeguards and Warnings....................................................................................................................... 3 Product Introduction .............................................................................................................................................. 4 Features ...
Welcome Thank you for purchasing an Amcrest camera! This user manual is designed to be a reference tool for the installation and operation of your camera. Here you can find information about the camera’s features and functions, as well as information to aid in troubleshooting. Many of the setup and installation sections have corresponding videos on YouTube. To access the setup videos, please go to http://amcrest.com/videos.
may cause overexposure of the picture or affect the longevity of the camera’s sensors. Ensure the camera is in a well-ventilated area to prevent overheating. 6. Operation and Maintenance Do not touch the camera sensor or lens directly. To clean dust or dirt off the lens, use an air blower or a microfiber cloth. 7. Accessories Be sure to use only the accessories recommended by the manufacturer. Before installation, please open the package and check to make sure that all the components are present.
1) Locate the position in which you would like to place your camera and using the base of the camera, mark the 4 installation holes with a marker onto the mounting surface. These holes will be used to drill the holes needed to mount your camera. 2) Using a drill bit that is the same diameter or slightly smaller diameter than the included drywall wall anchors, drill the 4 holes and insert the wall anchors into the holes.
Focal Length Viewing Angle Mount Type 3.6mm 90° M12 General Power Supply Power Consumption Working Environment Transmission Distance Ingress Protection Dimensions (W x D x H) Weight DC12C±25% Max 4W -40°F ~ 140°F / Less than 95% RH (no condensation) Over 1640ft via 75-3 coaxial cable IP67 Φ2.75” x 6.5” 0.77 lbs. Material Metal (body) + Plastic (sunshield) FCC Statement 1. This device complies with Part 15 of the FCC Rules.
be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. IC Warning Statement This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
substance or elements contained in products will not leak or mutate so that the use of these (substances or elements) will not result in any severe environmental pollution, any bodily injury or damage to any assets. The consumer is not authorized to process such kind of substances or elements, please return to the corresponding local authorities to process according to your local government statutes.
