User Manual

37
For more information on the settings listed in this menu, please refer to the information provided
below.
Channel: In the Channel list, select the channel that you want to connect the PTZ camera to.
Type: Local: Connect through RS485 port or coaxial cable. Remote: Connect through network by adding
IP address of PTZ camera to the DVR.
Control Mode: In the Control Mode list, select Serial. For series product, please select the control signal
is sent to the PTZ through the coaxial cable. For the serial mode, the control signal is sent to the PTZ
through the RS485 port.
Protocol: In the Protocol list, select the protocol for the PTZ camera, for example, select 3.0.
Address: In the Address box, enter the address for PTZ camera. The default is 1.
Note: The entered address must be the same as the address configured on the PTZ camera. If not
configured properly, the PTZ camera will not function in the DVR.
Baud Rate: In the Baud rate list, select the baud rate for the PTZ camera. The default is 9600.
Data Bit: The default is 8.
Stop Bit: The default is 1.
Parity: The default is None.
Click the Copy to button to copy the interface setting. Press the Refresh button to refresh the interface.
To confirm settings, click the OK button.
Channel Type
The channel type menu allows the user to configure specific channels types in the system. These channel
types include both Analog and IP channels configurations.
Analog Channel: Select the transmission medium such as CVI, CVBS, and then follow the onscreen
instructions to complete the settings.
IP Channel: Select a channel for IP camera from the last channel number. Select from the 5-6 check box.
Then follow the onscreen instructions to complete the settings.
Note: The 9-16 channels are only for IP cameras and are dependent on the model you purchased. The
channel selection for analog cameras or IP cameras are in sequence. For example, if you want to select
channels for IP cameras, you need to select 9-16 first then apply the analog channels.