User Manual

A hard drive - not included (unless you purchased a ‘kit’ that does have one included)

Four hard drive fastening screws – included

Note: Before installing the hard drive, make sure the DVR is powered off and completely disconnected

from power.

1. Loosen the screws on the

upper cover and side panel.

2. Attach four screws on the

HDD (Do not fully tighten, only

tighten about 3 times).

3. Place the HDD in accordance

with the four holes on the

bottom of the casing.

4. Turn the DVR upside down

and place the screws in firmly.

5. Tighten the HDD screws

firmly to the bottom of the

DVR.

6. Connect the HDD cable and

power cables to the

motherboard.

7. Put the cover back onto the DVR in

accordance with the clip and then

place the upper cover back onto the

device.

8. Secure the screws on the rear and

side panels.

Setting Up the Cables

The following instructions will show you how to set up the cables for the DVR, cameras (PoE and Wi-Fi),

as well as a monitor or TV screen.