Manualshelf

User Manual

ManualsBrandsAmcrest ManualsElectronics4K UltraHD 8 Channel AI DVR Security Camera System Recorder, 8MP Security DVR for Analog Security Cameras & Amcrest IP Cameras, AI Smart DVR, HDD & Cameras NOT Included (AMDV5108-AI)
71727374757677787980
80
Click and drag on the yellow bars to specify time zones for detection. To edit multiple days at once,
either click the checkboxes next to the names, or click the checkbox next to All to edit all the days at
once. Once the checkbox is clicked, press save to save and apply your detection settings. Click Cancel to
undo any changes and return to the motion detection settings screen. Click Default to use the default
settings.
The system allows for the configuration of up to 6 different time periods. Click the checkbox to the left of
the time period to enable that time period. Click the text next to each period to edit the time
period. To copy time periods, click the checkboxes next to the days of the week that you would like to
copy the settings to. Once finished on this screen, click Save to return to the time period settings screen.
Sensitivity: This dropdown menu allows the user to set the sensitivity level in which the event will be
detected. The levels can be set between 1 being the lowest and 6 being the highest sensitivity.
Record Channel: This checkbox allows the user to enable the system to record video for that channel
when a motion detection alarm is triggered. Delay is also associated with this tab; it is the This field
specifies in seconds how long the delay between alarm activation and recording should be.
Picture Storage: When an alarm occurs, the DVR triggers a snapshot for the selected channel.
Tour: Allows the user to enable the camera to activate a PTZ tour when a motion detection alarm is
triggered.
PTZ Linkage: Allows the user to active PTZ functionality to an applicable PTZ device.
Alarm Tone: Check this box to enable an imported voice prompt to be used if an event occurs. To use
this feature, select a file from the dropdown box in the File Name section.
More: Allows the user to access other motion detection options:
Anti-Dither: This field allows the user to set the anti-dither time. The values in this field can
range from 5 to 600 seconds. This time value controls how long the alarm signal lasts. Based on
motion detection, a buzzer can go off, a tour can begin, PTZ can be activated, a snapshot can be
taken, or a channel can begin recording.
Show Message: This checkbox allows the user to enable the system to show an on-screen
message when a motion detection alarm is triggered.
Buzzer: Check this box to enable a buzzer to be sound on your device if an event occurs.
Report Alarm: This option allows the system to upload the alarm signal to the network
(including alarm if you enabled current function).
Sub Screen: This option allows the system to provide a pop up of the alarm once it is triggered.
Log: Check this box to enable a log of the abnormality to be retained into the system.
Send Email: This checkbox allows the user to enable the system to send an email when a motion
detection alarm is triggered.
To reset to default settings, click the Default button. To copy the motion detection settings,
click on the Copy to button. To refresh the page, click the Refresh button. To save the settings
click the OK button.
Abnormality
This screen is used to specify system action in the case of either hard drive abnormality, or network
abnormality.