User Manual

84
Tour: Used to setup a tour for multiple channels. Please note, this is only applicable for PTZ
controlled devices.
PTZ Linkage: Allows the user to activate pan, tilt, and zoom options. Please note, this is only
applicable to PTZ controlled devices.
Alarm Tone: Plays an audio file set by the user once an alert is triggered.
More: Access additional settings such as, buzzer, alarm upload, log, send email.
Show Message: This checkbox allows the user to enable the system to show an on-screen
message when a motion detection alarm is triggered.
Buzzer: Check this box to enable a buzzer to be sound on your device if an event occurs.
Report Alarm: This option allows the system to upload the alarm signal to the network
(including alarm if you enabled current function).
Sub Screen: This option allows the system to provide a pop up of the alarm once it is triggered.
Log: Check this box to enable a log of the abnormality to be retained into the system.
Send Email: This checkbox allows the user to enable the camera to send an email when
an event is triggered. For more information on how to setup email alerts, please visit
amcrest.com/support
To reset to default settings, click the Default button. To refresh the page, click the Refresh
button. To save the settings, click the OK button.
How to Activate Face Detection
1. Click on the Face Detection menu located in the Parameters section and select the face
detection menu. Click on the Enable checkbox to enable the feature.
It is best to leave the Rule settings as default, however, they can be adjusted by clicking on the
Setting button. Use your mouse to adjust the minimum (Min) and maximum (Max) size of the
face detection area.