Manualshelf

User Manual

ManualsBrandsAmcrest ManualsBullet CamerasNightColor AI UltraHD PoE Bullet Camera w/ 66ft Full NightColor, Two-Way Audio, 256GB MicroSD Storage (Sold Separately), Amcrest Cloud, 113° FOV, 2.8mm Lens, 4MP@30fps
12345678910
7
MicroSD Card Installation Guide
To Install a microSD card into your camera, please refer to the step by step guide below:
1. Remove the security hatch cover located on the bottom of the camera with the included torx wrench.
2. Locate the provided microSD card slot and insert the microSD card into the slot, (Gold pins down).
3. Push the microSD card into the slot and release, the microSD card will then be locked into place and ready for use.
Basic Wiring Overview
On your device you will notice a pre-attached wire pigtail containing 5 wiring connections. These connections
contain a power adapter connection, an Ethernet connection, audio wires (I/O), and alarm wiring. This device
comes equipped with audio capabilities; the audio wiring is featured in the wire pigtail attached to this device.
There are no built-in speakers or microphones on this device. All audio for this device will be provided using
external third-party devices such as microphones and speakers.
The camera can use a basic 12V DC power adapter as a secondary power.
This connection is used to transmit data from the router to the device via an Ethernet cable.
This connection allows for the connection of a single channel, external RCA microphone to be
utilized for this device.
This connection allows for the utilization of a single channel, RCA speaker.
This connection provides alarm in and alarm out features to an external alarm or security
system. The basic overview of these wires are as follows: 1. Brown: Alarm_Out, 2. Green:
Alarm_Out_Ground, 3. Blue: Alarm_In1, 4. Gray: Alarm_In_Ground
Camera Access Setup
This section will provide information on how to setup and access your camera through the following methods:
• Local PC (Web User Interface (Web UI), Amcrest Surveillance Pro, etc.)
• Amcrest View Pro app
• Amcrest Surveillance Pro
• Amcrest Cloud
Default Username and Password
To login to the system for the first time, use one of the following default username/password combinations. Once
you have successfully logged in, it is highly recommended to change the password for security reasons.
Username: admin
Password: admin
Note: Logging in for the first time will prompt the user to change the password to the admin account.